Knowledgebase
I saw the message: "Please config the RAID first then carry on with FW installation to complete setup procedure"
Posted by - NA - on 29 December 2008 08:53
Please refer to N199 / N299 quick install guide, the last page showing we need to UPLOAD the firmware onto N199 / N299 to enable all of function on N199 / N299 since we create RAID completely.

If RAID was created completed and firmware was installed, after rebooting the system and system still didn't found the RAID, please remove the HDD on N199 / N299 and install them into PC,  and remove all of partitons on them as a brand new one. The then please install the HDD onto N199/N299, build RAID and upload firmware.  If you still get the same problem, please contact with your Thecus reseller / distributor for RMA service / replacement directly.
(855 vote(s))
Helpful
Not helpful

Comments (0)